Tag Archive: router

Jan 25 2014

Create own openwrt firmware for Gl-iNet router

Create own openwrt firmware for Gl-iNet router Inorder to create your own customise firmware, you need a linux operating system. My favourite is uses virtualbox from Oracle, there are readily linux images in virtualbox where you can just download and open it with virtualbox and I used this image LinuxMint 16 KDE 64bit

Continue reading »

Jan 10 2014

Mini router – GL-iNet (Part -1) – (Updated)

Mini router – GL-iNet (Part -1 ) Recently i got hold of this mini router GL-iNet, it is very much clone of TP-Link but, it has more and better specification. Details are available from their home page http://www.gl-inet.com Due to it larger flash and ram memory, we can customise the router to run on OpenWRT too.   …

Continue reading »

May 01 2013

SK-WMBRV1 4G-LTE Mobile broadband Router

SK-WMBRV1 4G-LTE Mobile broadband Router SK-WMBRV1 4G-LTE Mobile broadband Router is a heavily modified router done by me. It comprise of a removable USB mobile dongle from Huawei E3276 which is capable to support Cat 4 LTE and a removable Omni-directional 8dbi antenna for WIFI hotspot. This router has a low power consumption of 280mA (WIFI, …

Continue reading »

Jan 11 2013

Block all advertisement on home network

Block all advertisement on home network Finally after testing the scripts from http://goo.gl/mhykQ. I am able to a setup the similar AD Block to block out almost 99% of the advertisement on my home network.   Before Ad block After Ad Block  

May 30 2012

How to Configure Cisco router for SingNet ADSL

How to Configure Cisco router for SingNet ADSL Configure PPPoE support on Cisco router such as 827 / 837 cisco# en cisco# config term cisco(config)# no vpdn logging cisco(config)# vpdn-group 1 cisco (config-vpdn)# request-dialin cisco (config-vpdn-req-in)# protocol pppoe cisco (config-vpdn-req-in)# interface Ethernet0 cisco (config-if)# ip address 192.168.1.1 255.255.255.0 cisco (config-if)# ip tcp adjust-mss 1452 cisco …

Continue reading »

Feb 20 2011

How to delete router configuration

write erase command when in enable mode. This is an old command, but it is still supported, and works on all the switches and routers. On switches, also delete the vlan.dat file in flash otherwise it still ‘remembers’ the vlans configured. When you have done the command, reload the router, and it is back to …

Continue reading »